General Application and Simple Applicators You Can Use:

These instructions will help you use OdorAce in a safe, effective and low cost way.Ready to Use OdorAce is pre-diluted for your use.  Use it straight out of the bottle.

OdorAce is a “Contact” product. This means that OdorAce must come in direct contact with the material causing the objectionable odor in order to eliminate the odor.

When using OdorAce you must make certain that you use enough to penetrate to the imbedded sources. It must remain in liquid form long enough to wick into the same places that is emitting the odor.

Therefore, using applicator for the specific task at hand is an important part of getting the desired results from OdorAce.

• For very small areas, a trigger pump sprayer is completely acceptable.
• For small areas, a 1/2 gallon hand held tank sprayer will perform very well.
• For larger areas you may want to consider a 3 or 5 gallon garden or deck tank type sprayer.

Always start with a new sprayer and use it only for OdorAce.

Misting OdorAce will eliminate odors in the air.  OdorAce will literally take the smell apart.  The misting action will eliminate existing odors but will not prevent new odors from occurring.  In order to get permanent odor control, the surface of the area that is causing the odor must be treated with OdorAce.

If you have a smaller contaminated area (100 sq.ft. or so), a tank type yard sprayer will work fine.  These can be purchased at any hardware store and usually cost less than $20.00.  It is more important to thoroughly wet the affected area than it is to use a lot of OdorAce. You have to get the OdorAce on the odor causing material in order to permanently remove the odor.

If you add new garbage or disturb the surface of the treated material, you will need to re-spray the area that has been disturbed.